MachinesDrehen

GDW RD250S

Lever quick-action collet chuck mounted on the main spindle via an intermediate flange. For deadlength collets type 173E. Otherwise in the standard version according to the original documents available, GDW lever with pushbutton for spindle start-up, GDW material stop mounted on the grooving slide behind the center of rotation, monitoring by Beru switch using actuating plunger. Plunger diameter 5.0 mm, 3-color ready light with functions: "locked" - "standby" - "operation", GDW set-up key holder for safely bridging the stop function, very well-kept machine from a workshop for the disabled, little used

VDF - HEIDENREICH & HARBECK 18 RO

VOEST / Weiler Alpine E50 / 2

swing diameter over cranking 600 mm, spindle head according to DIN 55027 size 8, inner cone: metr. 70 / 1:20, max. Torque 1200 Nm, quill taper MK5, quill diameter 70 mm

SEIGER SLZ 500 E

without jaw chuck, contour calculation option and contour handwheel, Multifix mount, spindle head according to DIN 55027

EMCO TURN 342

After pressing "Aux on" the machine switches off with error X/Z axis. Drives and amplifiers are ok. According to EMCO Service, the error comes from the setpoint specification of the driven tools. The error messages were probably not broken down in detail at the time.

EMCO TURN 342

Breunig IRCO Profimat 65.8/270.8

Guide tubes are changed automatically using a revolver/drum

Ludwig & Fries

Ludwig & Fries

roller burnishing chair to finish shafts

IRCO ElektroVorschub

was attached to an EMCO lathe ET342

IRCO ElektroVorschub

was attached to an EMCO lathe ET342

MIVESA - das Original

Size C, Location hole for Multifix on the support, diameter 23 mm